Power500x1
1000 Watts Peak Mono Amplifier

Features a low-profile heatsink and a High-performance, low noise Surface Mount Design (SMT) preamp design.

  • High Current / High Efficiency Power Supply (MOSFET Design)

  • High Current Toshiba Output Transistors
  • Low Noise / Low Distortion Pre-Amp Circuitry
  • Optimized Class AB Design Minimizes Distortion and Reduces Idle Current
  • Designed to Drive 4 Ohm and 2 Ohm Loads
  • Continuously Variable Low Pass Filter 40Hz - 300Hz (12dB / Octave)
  • Continuously Variable Subsonic Filter 10Hz - 40Hz (12dB / Octave)
  • Continuously Variable Bass EQ 0 ~ 12dB at 45Hz
  • Crossover Bypass (Full Range)
  • Pass-Thru RCA
  • Short Circuit, Thermal and DC Offset Protection
  • Diagnostic LEDs: Green - Power / Amber Fault
  • Remote Level Control Ready (Sold Separately)

CEA Specifications:
Power Output: 325 Watts RMS x 1-Channel Into 4-Ohms @ 1% THD+N
Signal to Noise Ratio: 100dBA Below Reference (Reference: 1 Watt, 4-Ohms)

Additional Power Output:
500 Watts RMS x 1-Channel Into 2-Ohms @ 1% THD+N
Frequency Response: 10 Hz - 60 kHz, -3dB (Reference: 1 Watt)


Impedance    2 Ohm to 4 Ohm
Frequency Response    10Hz - 60kHz (-3dB)
THD+N @ 1 kHz, 1 Watt    0.02%
RMS Power    325 Watts, 4 Ohm
500 Watts, 2 Ohm
Signal to Noise Ratio    >100dB (@ Rated Power)
Dimensions    16" x 8.25" x W 2.125" (L x W x H)
Input Sensitivity    300mV-6V
Input Impedance    20 kOhms Nominal
Fuse/Type    2 x 35 Amp ATO Fuse
Weight    6.6lbs