POWER20001D
Mono class D amplifier

The Jensen POWER2000.1D mono class D amplifier will achieve greater AMPS will produce higher power efficiency and provide installation options due to its significantly reduced footprint. This Amp will also operate at lower temperatures and have the same piano finish that highlighted the new line introduction earlier in the year. The Jensen POWER2000.1D features 2000WATTS peak power, high and low pass filters, variable bass EQ, pass-thru RCA™s, encapsulated power and speaker connectors.

  • 1-ohm stable

  • Class D design for improved efficiency and size
  • High current MOSFET power supply and output transistors
  • Pass-through RCAs
  • Phase switch 0 ~ 180 degrees
  • Short circuit, DC - offset and thermal overload protection circuitry with diagnostic LEDs
  • Variable bass EQ 0 ~ 12 dB at 45Hz
  • Variable infrasonic high pass filter 10 - 40Hz (12dB / octave)
  • Variable low pass filter 40 - 300Hz (12dB / octave)
Low Level Input    Yes
Amplifier Class    Class D
Signal to Noise    >100dB
Number of Channels    1
Frequency Response    N/A
Total Peak Power    2000 Watts
Dimensions    11.3" x 2.0" x 8.1"
Sensitivity    400 mV-5V
Input Impedance    20k ohm
Fuse/Type    35 x 3 ATO
Rated RMS Power Per Channel 1-ohm    1000 x 1
THD+ N, @ 1 watt - Subwoofer    0.06%, (100 Hz)
Pass Through    Yes
High Level Input    No
Turn On Delay    Yes
Subsonic Filter    10-40Hz
Tone Controls - Bass/treble    No
Power Connector type    Encapsulated
Input level Control - Variable    Yes
Speaker impedance    1 - 4 ohm
Input selector Switch - 2ch/3ch/4ch    No
Remote Input Level Control    Yes
Sub Woofer Frequency Response High    10-300Hz (-3dB)
Rated RMS Power, Subwoofer 4-Ohm @ 2% THD    N/A
Rated RMS Power, Subwoofer 2-Ohm @ 2% THD    N/A
Total RMS Power @ 4-Ohm    450 Watts
Total RMS Power @ 2-Ohm    725 Watts
Bridgeable    N/A
Channel Seperation @ 1kHz    N/A
Protection Circuit - DC, Thermal & Overload    Yes
Heat Sink Type    Extruded
Crossover Low    40-300Hz
Crossover High    No
Weight    6.3 lbs.
Rated RMS Power Per Channel 4-ohm    450 x 1
Rated RMS Power Per Channel 2-ohm    725 x 1
Rated RMS Power, Bridged 4-ohm    N/A
Rated RMS Power, Bridged Stereo 4-ohm    N/A
Total RMS Power @ 1-ohm    1000 Watts
Bass EQ    Yes
THD+N @ 1 Watt - Full Range    N/A
Speaker Connector Type    Encapsulated